How to Change Basement Hopper Windows
Basement Hopper Windows – While there are many different styles of window sharpening, each with its own unique motion, the frame of most windows is similar. The installation of most varieties is almost identical. Hopper the windows are small, horizontal frames that lean on the hinges on the lower corners, so the top leans in. They are usually found in basements and other narrow spaces where larger windows cannot be installed. The window is usually in a wooden frame inside the opening, which is attached to the wall. The walls are often concrete or masonry. The new window attaches to the frame, so the standard fasteners are good.
How to change basement hopper windows. Tighten the enclosure around the window frame from the wall with the bent bar to reveal the gap between the windows and the wall frame. Pull nails through the back of the lists with locking pliers to preserve your face and save it for reinstallation. Cut the nails holding the window in place along both sides and on top with a tiger saw. Cut around the edge of the windowsill on the outside to release any old joint seal with a knife. Use a curved bar to bend the old window out of the opening from the outside.
Then to change basement hopper windows. Drag any cut nails from the frame into the window opening with locking pliers and scrape some old sealant from outside the wall. Place shims in the lower corners of the frame threshold for the new window. Enter the new window, centered, in the opening from the outside. Run a nail through the trim at the top of the window to secure it. Enter a level on the window board to check the pitch. Adjust shims under the window as needed until the bubble is centered. Nail through the windowsill in the wall frame behind the top and bottom corners of both sides. Adjust the window cover and nail it to the edge ofhow to change basement hopper windows